Refrigerator Operation Article from WESTERN APPLIANCE REPAIR BOISE 208-863-3702

Western Appliance Boise
HOME       BRANDS WE REPAIR       SERVICE AREA       PRICES       WARRANTY       CONTACT US

Whirlpool Repair Boise

maytag repair

Kenmore repair

kitchenaid repair

roper repair

Magic Chef Repair Boise

Jenn-Air Repair Boise

         ge repair

amana repair

And many more...

REFRIGERATOR REPAIR

FREEZER REPAIR

WASHER REPAIR

DRYER REPAIR

DISHWASHER REPAIR

OVEN REPAIR

Articles


View Larger Map

Our Technicians are factory trained..  We carry liability insured and stand fully behind our work.Oven Repair BoiseWasher Repair BoiseRefrigerator Repair BoiseDishwasher Repair BoiseDryer Repair Boise

Air Temperature Regulation of Refrigerators

As the food inside your refrigerator gets colder and colder it radiates less heat to the air inside the refrigerator.  The air temperature inside the refrigerator will remain colder as this process occurs.  To regulate the temperature inside most refrigerators and freezers either a thermostat is used or a thermistor/control board combination.

Thermostat Operation
A thermostat called a cold-control will cycle the compressor on and off to keep the temperature inside the refrigerator within a specified range.  Typical average temperature settings of most refrigerators will be around 45 F. You can always adjust the fresh-food temperature setting by turning the dials on the cold control.  Most cold-controls on Whirlpool, Maytag, Whirlpool, and GE refrigerators are located in the fresh-food side of the refrigerator, top and front near the interior light.

Thermistor/Control Board
A thermistor is an electrical device which changes resistance when a change in temperature occurs.  Thermistors are typically mounted on the inside walls of the fresh-food compartment, and also the freezer compartment.  The thermistor is connected electrically to the control board circuit.  The firmware in the control board is designed so that resistance of the thermistor will correspond to a given temperature and will adjust fan speed, fresh-food damper door, and compressor operation to achieve the set temperature.

On most repairs of Whirlpool, Kenmore, Maytag, and GE refrigerators all the cold air for both the fresh-food compartment and the freezer compartment is produced by one evaporator, which is located behind the rear interior panel of the freezer compartment.  Since the freezer air is so much colder than the fresh-food compartment, it is easy to see why it is logical to use this one evaporator to provide the necessary cold air for both the freezer and fresh-food compartments of most refrigerators.

Most of the cold air that is produced by the freezer/refrigerator evaporator circulates in the freezer compartment by the evaporator fan.  The evaporator fan also circulates air to the icemaker and through the damper door to provide cold air to the refrigerator.  Most of the damper door assemblies are located in the rear-top-left of the fresh food compartment.  Only a small amount of cold air needed in the food compartment to keep it down to the proper temperature so the damper door will close when the proper temperature is reached.  The control for this damper door is the other of the two dials within your refrigerator cold control or is adjusted via control board user interface.

For all your appliance repair boise needs, whether it be in Boise or in the surrounding cities such as Meridian, Eagle, or Star, give us at Western Appliance of Boise a call. 208-863-3702

 

Western Appliance Repair of Boise 13601 W McMillan Rd 102-236 Boise, Id 83713